The clock rates configured on each serial interface do not match. What could be causing this loss of quality? PAP authentication was misconfigured on the link interfaces. A network engineer is troubleshooting the loss of MPEG video viewing quality as MPEG video files cross a PPP WAN link. The serial interfaces participating in the multilink What PPP information will be displayed if a network engineer issues the show ppp multilink command on Cisco router? the link LCP and NCP status PPP uses LCPs to agree on format options such as authentication,Ĭompression, and error detection. PPP uses LCPs to establish, configure, and test the data link connection. PPP carries packets from several network layer protocols in LCPs. PPP can only be used between two Cisco devices. Which three statements are true about PPP? (Choose three.) PPP can use synchronous and asynchronous circuits. During a PPP session establishment phase, which two messages are sent by the requested party if the options are not acceptable? (Choose two.) ConfigureNak Which protocol will terminate the PPP link after the
Which three are types of LCP frames used with PPP? (Choose three.) linknegotiation frames Which three physical layer interfaces support PPP? (Choose three.) FastEthernet Which address is used in the Address field of a PPP frame? a single byte of binary 00000000 How does PPP interface with different network layer protocols? by using separate NCPsīy negotiating with the network layer handlerīy encoding the information field in the PPP frameīy specifying the protocol during link establishment through LCP Which is an advantage of using PPP on a serial link instead of HDLC? option for authentication
What type of Layer 2 encapsulation will be used for connection D on the basis of this configuration on a newly installed router: Serial 0/0/0 is administratively down, line protocol is down Serial 0/0/0 is down, line protocol is down Serial 0/0/0 is up, line protocol is down Which serial 0/0/0 interface state will be shown if no serial cable is attached to the router, but everything else has been correctly configured and turned on? Serial 0/0/0 is up, line protocol is up Which command can be used to view the cable type that is attached to a serial interface? Router(config)# show interfaces At which layer of the OSI model does multiplexing take place? Layer 1 Both the linkestablishment and network layer phase completed successfully. Neither the linkestablishment phase nor the networklayer phase completed successfully. Only the networklayer phase completed successfully. Which statement describes the status of the PPP connection? Only the linkestablishment phase completed successfully.
0 kommentar(er)
